Formascientificbiofree VERIFIEDzermodel8523manual
Formascientificbiofreezermodel8523manual ===== https://geags.com/2tvrKZ
How to Operate and Maintain the Forma Scientific Bio Freezer Model 8523
The Forma Scientific Bio Freezer Model 8523 is an ultra low temperature upright freezer that can store biological samples at -80ÂC. It has a capacity of 23 cubic feet and features a microprocessor control system, a vacuum relief port, a battery backup, and an alarm system. This article will provide some basic instructions on how to operate and maintain the freezer, based on the user manual[^1^] [^3^].
Operating the Freezer
Before operating the freezer, make sure it is properly installed and grounded according to the manual. Plug the freezer into a dedicated outlet that can supply the required voltage and current. Turn on the main power switch located on the front panel of the freezer. The display will show the current temperature and setpoint of the freezer. To adjust the setpoint, press the up or down arrow keys until the desired temperature is displayed. Press the enter key to confirm the new setpoint. The freezer will start cooling down to reach the setpoint.
The freezer has a number of alarms that indicate various conditions or malfunctions. The alarm will sound and a red LED will flash on the front panel. The display will also show an error code and a message describing the cause of the alarm. To silence the alarm, press the mute key. To reset the alarm, press and hold the reset key for three seconds. Refer to the manual for a list of alarm codes and their meanings.
Maintaining the Freezer
The freezer requires regular maintenance to ensure optimal performance and longevity. The following are some of the maintenance tasks that should be performed periodically:
Clean the condenser filter every three months or more often if it is dirty. The filter is located behind the lower front panel of the freezer. Remove the panel by lifting it up and pulling it out. Slide out the filter and wash it with warm water and mild detergent. Rinse and dry it thoroughly before reinstalling it.
Check the door gasket for cracks or tears every six months or more often if there are signs of frost buildup or temperature fluctuations. Replace the gasket if it is damaged or worn out. To replace the gasket, remove the screws that secure it to the door frame. Pull out the old gasket and insert the new one in its place. Tighten the screws evenly.
Defrost the freezer annually or more often if there is excessive ice accumulation on the inner walls or shelves of the freezer. To defrost the freezer, turn off the main power switch and unplug the freezer from the outlet. Transfer all the contents of the freezer to another storage device. Open the door and let the ice melt naturally. Do not use any sharp objects or heat sources to speed up the process as this may damage the freezer. Wipe off any water or ice with a soft cloth. Plug in and turn on the freezer and set it to -80ÂC. Wait until it reaches this temperature before reloading it with samples.
For more detailed information on how to operate and maintain the Forma Scientific Bio Freezer Model 8523, please refer to the user manual. aa16f39245